How to Export Gerber files from Altium PCB files
As Altium designer software is popularly used by most of PCB designers, but it normally originally work for .PCBDOC files not original PCB Gerber files which is exactly useful to PCB manufacturer, this page is introducing how to generate PCB Gerber file from Altium designer
PCB Design rule check
Make sure you run PCB design rule check (Tools->Design Rule Check…) before you generate Gerber files. DRC usually makes sure that your board doesn’t exceed the PCB manufacturer’s production abilities.
Our PCB manufacturing capabilities are outlined at the home page of /technology/pcb-capability/please using Design Rule Wizard to modify the rules accordingly.
Make sure there are no errors. If there are errors, you need to fix them before you can continue to generate Gerber files.
Generate PCB Gerber File
In PCB view, select File -> Fabrication Output -> Gerber files. Then in the popup dialog, select General tab, set Unit to inch and format to 2:5:
In Layers tab, select “Used On” for the Plot Layers drop down, select “All OFF” for Mirror layers. Check “include unconnected mid-layer pads”, and uncheck “Mechanical layers to Add to All plot”:
In the Drill Drawing tab, deselect all check boxes, and select Graphic Symbols:
In Apertures tab, make sure RS274X is selected:
In Advanced tab, select “Separate file per layer” for Batch Mode option. Also select “Suppress leading zeros” for Leading/Trailing Zeros, select “Reference to relative origin” for Position on Film and select “Unsorted” for Plotter Type, then click OK:
After a few seconds, Gerber files are generated. You don’t need to save the generate CAM file, just close it.
Generate NC Drill File
Then in the PCB view, select File -> Fabrication Outputs -> NC Drill Files, in the NC Drill Setup dialog, select “Inches” for Units, “2:5” for Format, “Suppress leading zeros” for Leading/Trailing Zeros and “Reference to relative origin” for Coordinate Positions, then click OK:
Click “OK”:
Click “OK”:
Package Gerber File
Altium saves all generated Gerber and NC Drill files in the “Project output folder”, usually it is in the same folder as your PCB project folder. Rename the project output folder to something meaningful so you know what it is.
Then zip all files in the output folder and send to us for PCB fabrication.
The following summarizes the Altium Gerber file extensions:
=============================
GTL—Top layer
GBL—Bottom layer
GTO—Top overlay
GBO—Bottom overlay
GTP—Top paste
GBP—Bottom paste
GTS—Top solder
GBS—Bottom solder
G1 —Midlayer 1
G2 —Midlayer 2
…
GP1—Internal plane 1
GP2—Internal plane 2
…
GM1—Mechanical 1
GM2—Mechanical 2
…
GKO—Keepout layer
GG1—Drill guide
GD1—Drill drawing
GPT—Top pad master
GPB—Bottom pad master
=============================
How to generate pick and place file from altium file